UDT Out DAT
The UDT Out DAT is used for sending information over a UDT connection between remotely located computers.
Although it is an 'Out' node, it can receive reply messages from the machine(s) it sends to. The messages will appear in the DAT's contents (just like the UDT In DAT).
Tscript uses the
send Command to initiate the data output.
See also: UDT In DAT
NOTE for Windows OS - If experiencing connection issues make sure Windows Firewall is disabled.
Parameters - Connect Page
protocol - ⊞ - Selects the network protocol to use. Refer to the Network Protocols article for more information.
- Fast Streaming
- Reliable Messaging
port - The network port to send to.
shared - Use the same connection as other networking DATs using the same network protocol.
format - ⊞ - Determines how the incoming data is parsed.
- One Per Byte
perbyte- One row is added to the table per byte received.
- One Per Line
perline- One row is added to the table per line received.
- One Per Message
permessage- One row is added to the table per message received.
active - This check box enables the connection.
Parameters - Received Data Page
callbacks - The Callbacks DAT will execute once for each message coming in.
executeloc - ⊞ - Determines the location the script is run from.
- Current Node
current- The script is executed from the current node location.
- Callbacks DAT
callbacks- The script is executed from the location of the DAT specified in the Callbacks DAT parameter.
- Specified Operator
op- The script is executed from the operator specified in the From Operator parameter below.
fromop - The operator whose state change will trigger the DAT to execute its script when Execute from is set to Specified Operator. This operator is also the path that the script will be executed from if the Execute from parameter is set to Specified Operator.
clamp - The DAT is limited to 100 messages by default but with Clamp Output, this can be set to anything including unlimited.
maxlines - Limits the number of messages, older messages are removed from the list first.
clear - Deletes all lines except the heading. To clear with a python script
bytes - Outputs the raw bytes of the message in a separate column.
Parameters - Common Page
language - ⊞ - Select how the DAT decides which script language to operate on.
input- The DAT uses the inputs script language.
node- The DAT uses it's own script language.
extension - ⊞ - Select the file extension this DAT should expose to external editors.
dat- various common file extensions.
- From Language
language- pick extension from DATs script language.
- Custom Extension
custom- Specify a custom extension.
customext - Specifiy the custom extension.
wordwrap - ⊞ - Enable Word Wrap for Node Display.
input- The DAT uses the inputs setting.
on- Turn on Word Wrap.
off- Turn off Word Wrap.
|• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •|
Some operators have a DAT docked to them that contains some python functions. These functions, called "callbacks", get called when something in the operator changes.